It is unclear at this time if other makes/models/brands outside of the NAR markets use actual coding alone, however several bits are available in the Long Coding Helper.Discussion related to 2017 NAR market Jetta headlights with LED DRLs can be found here: 2017 Jetta SE TSI DRL wink.This input is not monitored by the BCM for fault code recognition and simply removing the 'TFL' pin at the headlight switch will disable DRL operation. The 2011+ Jetta and 2012 Beelte from the US/Canadian (NAR) market use a hardwired 'TFL' signal into the BCM for DRL operation.Select 'Lights: Comfort Turn Signals' from the drop down list, choose 0 = Comfort Turn Signals inactive -OR- 1 = Comfort Turn Signals active. Turning On/Off the feature is found in Adaptation.Note: MY 2011 Golf owners reported: Change comfort turn signals count in the VW Vortex Coding or MFA / dash options may apply to this setting in some cases.Select 'Lights: Comfort Turn Signals (Cycles)' from the drop down list, choose the number of flashes and Save. Number of flashes found in Adaptation.Example: Comfort Function for Power Windows via Remote Control activeĬlose the Long Coding Helper by clicking the Windows X box on the top right of the screen or clicking the Exit button on the top left of the screen to send your altered Coding value back to the Coding screen.Ĭomfort Turn signals Number of flashes and turning On/Off the feature Check or Un-check the boxes for the desired results. Or the module you intend on tweaking as per the list belowĬlick on each of the Byte numbers in row 3) and you'll see the selectable options below. Click on each of the Bytes and Bits for the documented options and check or un-check the appropriate boxes as shown in the example below: Note: Make sure to have all Doors unlocked, otherwise this Control Module may not communicate with the Scan Tool / VCDS.Īll modifications are found in Found in > Long Coding Helper unless otherwise noted. Central Electronics / Body Control Module (BCM)

This may not be supported on all control modules.From the drop down list, choose Storage of seat heater level driver. 1, 2 or 3) should resume the previous level upon restarting the car. Enable Indirect TPMS using the documented Long Coding Helper information and the forum feedback here: How to: retrofit indirect Tire Pressure Monitoring in 5 minutes.Alter the HHA (Hill Hold Assist) using the documented Channel while connected to the vehicle.On Vehicles using the MK60EC1 ABS system it may be possible to: 3 - Central Electronics / Body Control Module (BCM).

Vcds coding guide pdf